Install Darktable 4.4.0 on Ubuntu and Linux Mint

Darktable logo

This guide will show you how to install Darktable 4.4.0 on Ubuntu or Linux Mint.

Introduction to Darktable

Darktable is a powerful open-source photography workflow software that allows photographers to manage and edit their digital images. It is available for Linux, macOS, and Windows.

Darktable provides various modules for tasks such as raw image processing, color correction, noise reduction, and lens correction, making it a versatile tool for photographers of all levels.

Prerequisites

  • sudo access required
  • Ubuntu 20.04 and Linux Mint 19 or later.

Darktable’s Features

Non-destructive editing: Darktable preserves your original files and allows you to make changes without permanently modifying them. This means that you can experiment with different settings and revert back to your original image at any time.

RAW processing: Darktable can process RAW images, which are the unprocessed files that are captured by your camera’s sensor. This gives you much more control over the look of your images than if you were to edit JPEGs.

Tone curves and levels: These tools allow you to fine-tune the tonal range and contrast of your images. This can be used to improve the overall look of your images, as well as to correct problems such as overexposed or underexposed areas.

Noise reduction: Darktable can reduce unwanted noise and graininess in your photos, particularly in low-light conditions. This can help to improve the quality of your images and make them look more professional.

READ  How to Install WineHQ 8.13 on Ubuntu: A Step-by-Step Guide

Lens correction: Darktable can correct lens distortions and aberrations. This can help to improve the overall sharpness and clarity of your images.

Install Darktable 4.4.0 on Ubuntu

Make sure Flatpak is installed on the system before proceeding, you can check it using the below command

flatpak --version

If Flatpak is not installed, install it by using the below command

sudo apt install flatpak

After Flatpak installation proceed with the installation of Darktable

flatpak install flathub org.darktable.Darktable

Once Darktable is installed run the below command to start the application

flatpak run org.darktable.Darktable

Uninstall Darktable

Uninstalling Darktable using Flatpak is a straightforward process, just execute the below command in the terminal.

flatpak remove org.darktable.Darktable

Conclusion

In this tutorial, we have shown the easiest method to install Darktable 4.4.0 on Ubuntu and Linux Mint.

Do let us know your comments and feedback in the comments section below.

If my articles on TipsonUNIX have helped you, kindly consider buying me a coffee as a token of appreciation.

Buymeacoffee

Leave a Comment